Radio Shack Light and Learn Remote - Manual (Page 24)

24 Troubleshooting
1. On the remote control, press the desired device
key once.
2. Hold down P until the red light blinks twice.
3. Press 9 9 0 . The red light blinks twice.
4. To view the code for the first digit, press 1 . Count
the number of blinks (for example, if there are
three blinks, the first digit is 3) and write down the
number.
Note: The red light will not blink if the code digit is
a “0”.
5. Repeat Step 4 three more times for each succes-
sive digit by pressing and releasing 2 , 3 , and 4 .
X
Troubleshooting
If the remote control stops working after you have suc-
cessfully tested the control for each device, or if you
are unable to get the remote control to work at all, do
the following:
• Be sure you press the device key for the device
you want to control before you press any other
key.
• Confirm that your IR devices are working properly
by using the original remote control or the manual
controls.
• Replace the batteries.
If you have any other problems, call customer service
at 888-631-9859.
CARE
Keep the remote dry; if it gets wet, wipe it dry immedi-
ately. Use and store the remote only in normal temper-
ature environments. Handle the remote carefully; do
not drop it. Keep the remote away from dust and dirt,