Final installation procedure and commissioning – Redring EXPRESSIONS 570 User Manual

Page 9

Advertising
background image

9

5. A dual position cable clamp is provided. For

top cable entry use retaining bar in horizontal
position supplied. For bottom cable entry
rotate retaining bar to the angled position.

6.

WARNING: THIS APPLIANCE MUST BE
EARTHED.

7. The earth

continuity
conductor of
the electrical
installation
MUST BE
effectively
connected
electrically to all exposed parts of the
appliances and services in the room in which
the water heater is to be installed in conformity
with the current BS. 7671 (I.E.E. wiring
regulations).

FINAL INSTALLATION PROCEDURE
AND COMMISSIONING

WARNING : DO NOT SWITCH ON THE
ELECTRICITY SUPPLY UNTIL THE
FOLLOWING PROCEDURE HAS BEEN
COMPLETED. FAILURE TO DO SO COULD
CAUSE THE PUMP TO RUN DRY AND
INVALIDATE THE GUARANTEE.

1. Fit the front cover back into position, ensuring

that both the control knobs are correctly
aligned with the flow valve and power selector.
Secure with top and bottom screws.

2. Fit hose and prime the shower first without the

handset to flush out any remaining debris. To
prime the shower ensure that the electricity
supply is switched off. Turn control knob 'B'
fully anti-clockwise. Water should start to flow
with motor switched off allowing all the air to
be purged out of the shower unit.

It may be necessary to lower the hose
below the level of the shower unit whilst
priming.

Stop water flow by turning knob 'B' fully
clockwise. Attach handset, switch on electrical
supply and then operate the shower as on
page 2 and check–

a) That the water gets to a satisfactory

temperature

b) Water flow can be adjusted by knob 'B'

c) Power selection operates in both positions,

giving a change in water temperature

d) Check again for leaks

e) That the holes in the spray plate are not

blocked

f)

That the motor turns off and water stops
flowing in the 'STOP' position

3. DEMONSTRATE OPERATION TO THE USER

Please leave these instructions with the user
for future reference.

ADDITIONAL ACCESSORIES

Cat. No.

White 2 metre shower hose

83-593529

1 metre riser rail

83-593530

Water control tap

93-792452

Shower de-scaling powder

95-711015

Curtain and rail pack

83-792802

Curtain and rail pack with non
slip bath mat

83-792801

Spare parts/accessories can be supplied
against any Visa or Access cards from
Redring Sales 01733 456700.

INLET ASSEMBLY SHOWING FILTER
POSITION

8mm

5mm

10mm

10mm

33mm

Live
Earth
Neutral

Diagram 10

Diagram 11

Advertising