RF-Link ABM-4161 - Manual (Page 4)

4
Set Up
Camera Setup
1.1
Power Supply
Loading the Batteries (See Fig. 3)
1. Loosen the screw on the bottom of the camera by using a screw driver. (Step 1)
2. Open the battery compartment cover. (Step 2)
3. Insert 4 AAA-size batteries (follow the plus (+) and minus (-) signs inside the battery compartment). (Step 3)
Note : The camera uses either 4 AAA batteries (alkaline battery recommended) or AC power current.
4. Close the battery compartment cover, and make sure it is locked securely.
Note 1: Do not mix old batteries with new ones.
Note 2: Remove the batteries from the camera if you do not plan to use it for a prolonged period of time.
5. Slide the POWER switch to the ON position. The LED on the camera (red light) will light up. (Step 4)
Note: When battery power is sufficient, the light is constantly red; when it is low, the LED light will start blinking.
Using AC Power (See Fig. 4)
1. Plug one end of the power adapter into a wall outlet and the other end into the bottom of the camera. (Step 1, 2)
2. Slide the ON/OFF switch to the ON position. The LED on the camera (red light) will light up. (Step 3)