RF-Link ABM-4161 - Manual (Page 6)

6
1.4 Night vision
The camera has nine high-intensity LEDs for picking up clear images in the dark. When the built-in photo sensor detects
low ambient light levels, the LEDs will automatically activate.
Monitor Setup
2.1 Power Supply
Loading the Battery (See Fig.7)
1. Open the battery compartment cover on the rear of the monitor. (Step 1)
2. Insert the battery and make sure the polarity is correct. (Step 2)
Note: The monitor uses 3.7V 1000mAH (Li-ion) battery or the household AC power.
4. Turn the monitor on. (Step 3)
Note 1: When battery power is sufficient, the light is constantly red; when it is low, the LED light will start blinking.
Note 2: Remove the battery from the monitor if you do not plan to use it for a prolonged period of time.
5. Adjust the volume to a comfortable level.
Using AC Power (See Fig. 8)
1. Plug one end of the power adapter into a wall outlet and the other end into the bottom of the monitor. (Step 1, 2)
2. Turn the monitor on. (Step 3)
3. Adjust the volume to a comfortable level.
Note 1: When charging starts, the "POWER" LED will appear blue. If charging is finished (fully charged), the
"POWER"LED light will turn red.
Note 2: When the camera and the monitor is linked, the "Link" LED will become green; otherwise, the "Link" LED
will become red and blinking.