Rhino Mounts SE4 - Manual (Page 11)

SAFETY
SE4 05/05 Safety Section 1-5
© 2005 Alamo Group Inc.
SAFETY
Equipment Operation Safety Instructions and Practices
Use extreme caution when getting onto the Implement to perform repairs, maintenance and when
removing accumulated material. Only stand on solid flat surfaces to ensure good footing. Use a
ladder or raised stand to access high spots which cannot be reached from gound level. Slipping
and falling can cause serious injury or death.
(SG-33)
Avoid contact with hot surfaces including hydraulic oil tanks, pumps, motors, valves and hose
connections. Relieve hydraulic pressure before performing maintenance or repairs. Use gloves
and eye protection when servicing hot components. Contact with a hot surface or fluid can cause
serious injury from burns or scalding.
(SG-34)
DO NOT operate this Implement on a Tractor that is not properly maintained. Should a
mechanical or Tractor control failure occur while operating, immediately shut down the Tractor and
perform repairs before resuming operation. Serious injury and possible death could occur from
not maintaining this Implement and Tractor in good operating condition.
(SG-36)
Avoid contact with hot surfaces of the engine or muffler. Use gloves and eye protection when
servicing hot components. Contact with a hot surface or fluid can cause serious injury from burns
or scalding.
(SG-38)
Do not put hands or feet under mower decks. Blade Contact can result serious
injury or even death. Stay away until all motion has stopped and the decks are
securely blocked up.
(SGM-9)
Always keep a careful lookout and use extreme care when working around utility and municipal
obstructions. Never allow the Mower to contact any utility, municipal, or other type structure.
Clearly mark all mowing obstructions and consult local utility providers for a safe code of
operation.
(SPU-5)
Do not operate the implement while wearing loose fitting clothing. Entanglement of the clothing
with the rotating elements can result in serious injury or even death. Stay clear of all rotating
elements at all times.
(SSP-3)
Never leave the Tractor and Implement unattended while the Implement is in the lifted position.
Accidental operation of lifting lever or a hydraulic failure may cause sudden drop of unit with injury
or death by crushing. To properly park the implement when disconnecting it from the tractor,
lower the stand and put the retaining pin securely in place, or put a secure support under the A-
Frame. Lower the implement carefully to the ground. Do not put hands or feet under lifted
components.
(S3PT-1)