Rhino Mounts SE4 - Manual (Page 128)

MAINTENANCE
SE4 05/05 Maintenance Section 5-10
© 2005 Alamo Group Inc.
MAINTENANCE
DISASSEMBLY OUTPUT SHAFT (FIG Mnt-R-0042)
1.Install slotted nut (Ref 18, Mnt-R-0040) onto shaft and then tap shaft end on solid surface to remove
lower bearing and spacer.
2.Remove snap ring (Ref #7) and then repeat above procedure to remove upper bearing.
ASSEMBLY
1.Assembly of output shaft is accomplished in exact reverse order. Install bearing over shaft and press
up against bottom end of gear. Install snap ring (Ref. #7 Mnt-R-0040).
2.Install spacer and lower bearing on shaft. NOTE: Bearing Spacer (Ref #6) may be two different
lengths and each spacer requires a different bottom cap.
LOWER BEARING RETAINER CAP (Figure Mnt-R-0043)
1.Remove old seal from cap and press in new seal. (See SEAL INSTALLATION
RECOMMENDATIONS).
Note difference between bearing caps shown to make sure proper part is being used.\