Roberts Radio DreamDock - Manual (Page 23)

If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
22
Scan sensitivity setting - FM
Your radio will normally scan for FM broadcasts which are strong enough
to give good reception. However, you may wish the Auto-scan function
to also be able to fi nd weaker signals, possibly from more distant radio
transmitters. Your radio includes a local / distant option for the Auto-scan
function.
1. Press the On / Off control to switch on your clock radio.
2. If needed, press and release the Mode button until the FM band is
selected.
3. Press and release the Menu button.
4. Press the Tuning Up or Down buttons until the display shows 'Scan
Zone'. Press and release the Select button to enter the scan zone
selection menu.
5. Press the Tuning Up or Down buttons to switch between Local and
Distant options on the lower line of the display. The Distant option will
allow the radio to fi nd weaker signals when scanning.
6. Press and release the Select button to confi rm your selection. The
radio will then revert to the normal information display. The Local or
Distant setting is stored in the radio and remains in force until changed
or until a System Reset.
Note: The initial setting (out of the box, or after a System Reset) causes
the radio to ignore weaker (or more distant) signals.
1
3
4,5 4,5
4,6
2