Ramsey Electronics PR20 - Manual (Page 8)

PR20—8
two mechanical points after making sure that L1 is pressed firmly against the
component side of the PC board.
PROGRESS SUMMARY: The wiring of your Ramsey PR series preamp PC board is now
complete. It will take you less than a minute to completely recheck every single soldering
connection as well as for the appropriate part installations.
Correct parts placement checked.
PC board soldering checked...touched up if needed.
INPUT AND OUTPUT CONNECTIONS
Use short pieces of miniature coax such as RG-174 to connect the PC board input and
output points to the RF connectors you wish to use. For the neatest installation, it is good
practice to pre-tin the coax ends before soldering to the PC board. Plan your probable
applications with as much foresight as possible so that you don’t spend more on cable
adapters than you did on the kit!