Raymarine RS12 - Manual (Page 7)

Important Information 7
Suppression Ferrites
If a suppression ferrite is attached to a cable, this ferrite should not be removed. If
the ferrite needs to be removed during installation it must be reassembled in the
same position. If a ferrite is packed separately in the carton, it must be installed as
soon as the cables are run.
The following illustration shows typical cable suppression ferrites sometimes
used with Raymarine equipment. To ensure EMC compliance, always use these
ferrites, if supplied by Raymarine for use with this equipment. If not supplied by
Raymarine, a ferrite is not required for use with this equipment.
Connections to Other Equipment
If your Raymarine equipment is to be connected to other equipment using a cable
not supplied by Raymarine, the suppression ferrite (if supplied) MUST always be
attached to the cable nearest the Raymarine unit.
TFT LCD Displays
The colors of the display may seem to vary when viewed against a colored
background or in colored light. This is a perfectly normal effect that will be seen
with all color LCD displays.
In common with all Thin Film Transistor (TFT) LCD displays, the screen may exhibit
a few (less than 5) wrongly illuminated pixels. These may appear as black pixels in
a light portion of the screen or as colored pixels in black areas.
CAUTION: To provide protection against the damaging effects of
UV light, Raymarine advises that you replace the sun cover
provided when the color LCD display is not in use.
Product Disposal
When you want to dispose of this product at the end of its working life, please do
so in accordance with local regulations.
D3548-3