Roland VC-200HD - Manual (Page 29)

Basic Operations
29
The display shows the status of the device. It also shows the menu
screens for the various settings.
* The display may be difficult to read depending on the angle from
which the unit is viewed. The character contrast on the display and
brightness of the backlight are adjusted with the "900: LCD
Contrast" and "901: Light Dimmer" settings (p. 37) from the Menu
(p. 30).
• Status Screen
* For details see "Status Screen" below.
• Menu Screen
* For details, see "Menu Display and Operation" (p. 30).
Panel Lock
When the PANEL LOCK button is lit, “Panel Lock!!” is displayed and
no operations can be performed if any button other than the PAGE
button is pressed. To release panel lock, press and hold down the
PANEL LOCK button for at least two seconds. When panel lock is
released, the PANEL LOCK button goes out.
The Status screen shows the status of the unit. When power to the unit
is turned on, the Status screen is displayed.
There are four types of Status screens. Press the PAGE button to
change the display.
• Video Input/Output Format
• Audio Level CH1, CH2
• Audio Level CH3, CH4
• Audio Delay
• Timecode
Video Input/Output Format
Displays the video input/output format.
a
Displays the input connector.
* The input connector is selected with “Selecting the video input
connector” (p. 26).
b
Displays the video input format.
* When no video is input to the input connector shown in a., "--------"
is displayed.
c
Displays the video output format.
* The video output format is selected with “Selecting the video
output format” (p. 27).
Audio Level CH1, CH2
Audio Level CH3, CH4
a
Displays the connector where audio is being output.
b
Displays the input audio level of a. The peak is held for
a set time.
* The audio level cannot be adjusted from this screen. Adjust the
audio level from "330: Audio OutCh1&2 Lv" and "331:
AudioOutCh3&4Lv" (p. 35) from the Menu (p. 30).
* If the audio level is high and the display on the Status screen
exceeds 0 dB, the output audio may be distorted. In this case,
control the audio level on the device inputting audio to this unit or
control the audio level with "330: Audio OutCh1&2 Lv" and "331:
AudioOutCh3&4Lv" (p. 35) on the above Menu (p. 30).
Audio Delay
Displays the amount of audio delay in units of frames. The value in ()
displays the audio delay in milliseconds.
* Set audio delay using the procedure in "Setting internal
processing" (p. 28).
Timecode / User Bit
Displays the time code and user bit output from the i.LINK connector
and HD-SDI OUT connector.
a
Displays the timecode.
* If the frame rate of the input video (p. 26) and the output format (p.
27) are different, the displayed timecode is generated internally.
b
Displays the user bit (p. 35).
c
Displays drop frame (D) or non-drop frame (ND).
Showing the Display
Status Screen
Display
b a c
a b
a b d