RightWay GPS Navigator RW 430 - Manual (Page 16)

16
Adjuster Dial
Up & Down
Pull Tab
RW 430 MOUNTING SYSTEM
Included in your package, you will find a mounting solution to easily secure your
RightWay Navigator to either the windshield or the dash.
Caution! It is illegal in California and Minnesota to attach anything to the windshield.
Caution! When using navigation aids in a vehicle, it is your sole responsibility to place,
secure and use these aids in a manner that will not cause accidents, personal
injury, property damage, or in any manner to obstruct your view. You, the user
of this product, are solely responsible for observing safe driving practices.
1. Select a suitable location on the windshield or dashboard for
the mount. Clean and dry this area to remove any grease and dirt.
2. If mounting the GPS on the dashboard, remove the protective
backing from the dash disc, exposing the adhesive. Adhere
the disc to the dashboard in the desired location.
Note: The adhesive is permanent.
3. With the locking lever in the up position, hold the suction cup to the windshield or on the
dash disc with the locking lever and pull tab on top.
4. Push the locking lever towards the base of the mount. The mount should suction to the
surface.
5. Align the tabs on the holder with the slots on the Navigator cradle. Slide together until
you feel a firm click.
6. Adjust the holder to the best viewing angle by loosening the adjustor dials, moving the
corresponding part to the desired position, and then tightening the adjustor dial.
7. To remove the mount, pull the locking
lever away from the base, and then
gently pull on the pull tab. This should
break the suction so you can remove
the mount.
Dash Disc
Adjuster Dial
Right & Left
Locking
Lever
(in up
position)