RCA MM27110 - Manual (Page 52)

50
Menus and Features
Editor Menu Action Buttons
While browsing the Editor menu, the following Action buttons are
available on the bar:
• Cancel Press 1 on the remote to cancel any changes made since
entering the Editor Menu.
• Change Press 2 on the remote to change the channel number for
the highlighted channel line.
• On/Off Press 3 on the remote to toggle the state of the channel
between On and Off.
Setup
The Setup Menu lets you access GUIDE Plus+ System setup information.
To access the Setup option:
1. Press MENU on the remote to highlight the Menu bar.
2. Use the arrows to highlight the Setup menu option.
3. Use the up and down arrows to select Setup, View Demo, or
Options:
• Setup Displays the GUIDE Plus Gold System setup screens.
Setting up the GUIDE Plus+ Gold System is detailed in the
Setting Up section of this book.
• View Demo Runs the GUIDE Plus+ Gold System
demonstration.
• Options Displays the GUIDE Plus+ Gold autodisplay options.
On Automatically displays the GUIDE Plus+ Gold System
when you use the TV button on the remote to turn on the
TV.
Off Disables the GUIDE Plus+ Gold System from being
displayed when you use the TV button on the remote to
turn on the TV.
Expanded Information
To view more information about a program, advertisement or special,
highlight the channel listing or ad/show information box and press the
INFO button. Requesting more information about a particular show will
also display the PlusCode programming number and the Shows on Next
for that channel.
Pressing INFO while highlighting an ad panel will fill the screen with any
additional and/or promotional information regarding that particular
program.
Pressing the INFO button again exits the expanded information screen.
Editor
Menu
Selection
Editor Menu
Action Buttons
Ad/Show Information
Troubleshooting
Troubles sometimes are caused by simple
“faults” that you can correct without a
service technician. Here are a few basic
remedies:
Program information does not download
• Review your setup information and
make sure it is correct.
• The monitor must be off to download
information. Leave your monitor off
overnight, for at least 10 hours, to
receive a download for your area.
• If you are using a cable box, make sure
the cable box is on in order to receive
program information.
• If you are using a VCR, make sure the
VCR is off in order to receive program
information.
Scheduled Watch or Record does not occur
• Check Schedule for timer conflicts.
• Check that G-LINK cable wand is
positioned correctly.
• Make sure there is a tape in the VCR and
that the G-LINK wand is properly
positioned and the VCR is off.