Raymarine 530 - Manual (Page 27)

Chapter 2: Getting Started & Adjusting the Display 2-3
Si
m
ula
to
r Mo
de
➤ To switch the display unit off, press and hold the POWER key for three
seconds. A countdown timer is displayed as shown below:
Figure 2-2: Switch Off
When the counter reaches zero a beep sounds, and the display unit switches
off. Release the POWER key.
Note: Switch the display unit off before you remove the power cord.
Simulator Mode
When simulator mode is on a simulator data box is displayed.
When the display is switched off then on again, simulator mode is maintained.
It is recommended that you select the System Set Up Menu and switch off
simulator mode when you have finished.
➤ To view a simulated image:
1. Press MENU followed by the SYSTEM SET UP soft key.
The set up menu pop-up is displayed.
2. Use the trackpad to move the selection bar over the option SIMULATOR. The
simulator soft keys are displayed.
3. In the system set up menu, press DATA to view the chart display with simu-
lated position.
4. Press ENTER twice to return to the default display.
Note: Any waypoints placed on the chartplotter in simulator mode are re-
tained in the database list and are available for use in routes.
DISPLAY GAIN
VRM/EBL
MULTI
MARKS
ALARMS RANGE
ENTER CLEAR MENU POWER
Countdown timer:
number of seconds
to power off
SECONDS
3
D3599-1
POWER OFF IN
3s
MENU
SYSTEM
SET UP¬