Radio Shack CID-927 - Manual (Page 7)

7
CONNECTING THE
PHONE
Plug one end of the supplied modular
cord into the jack on the back of the
CID-927. Then plug the other end of the
cord into the modular phone line jack.
CONNECTING THE
HANDSET
Plug one end of
the supplied coiled
modular cord into
the jack on the left
side of the phone
and the other end
into the jack on the
handset. Then
place the handset
on the base.
SETTING THE DIALING
MODE
Set TONE/PULSE on the back of the
base for the type of service you have. If
you are not sure which type you have,
do this test.
1. Be sure TONE/PULSE is set to TONE .
2. Lift the handset and listen for the
dial tone.
3. Press any number except 0 .
Note: If your phone system requires that
you enter an access code (
9 , for exam-
ple) before you dial an outside number,
do not press that number.
If the dial tone stops, you have touch-
tone service. Leave
TONE/PULSE set to
TONE .
If the dial tone continues, you have
pulse service. Set
TONE/PULSE to
PULSE .
SETTING THE RINGER’S
VOLUME
Set RINGER OFF/LO/HI on the back of
the base to LO for a normal ringer vol-
ume, or HI for a louder ring.
TONE/PULSE
RINGER OFF/LO/HI
43-927.fm Page 7 Thursday, June 24, 1999 9:36 AM