Revox Re:source MK3 - Manual (Page 5)

5.1 Decoder Module 3 Re:source
4
Installation
The 5.1 Decoder plug-in card
has the most modern
technology on it and should be
handled with care.
Before you start to install the
card, the M51 must be switched
off and the power plug must be
removed from the power socket.
Slot 7 is reserved for the
Decoder module, right next to
the speaker connections. No
other module should be plugged
in to this slot because this
provides the shortest possible
signal route to the outputs.
Loosen the two screws with the
TORX screwdriver supplied and
remove the slot blanking plate.
Before removing the Decoder
module from its packaging,
make sure that you are not
charged with any static
electricity. This could cause a
damaging power discharge
when you touch the module.
To be on the safe side, you
should discharge any static
from yourself by touching an
earthed metal object such as a
radiator.
Remove the decoder module
from its packaging and insert it
into the slot position, using the
two tracks within the M51 to
guide it into position. The
lettering on the card must be at
the top. Just before the card is
fully inserted, you will feel a
certain mechanical resistance
as the card meets the M51
contact strip. Push the card fully
home by pushing in the area
where the 2 screw holes are
located and fix it in place with
the two screws.
All further steps needed to
integrate the new module into
the M51 will be carried out
automatically next time the unit
is switched on.