Ramsey Electronics MX10 - Manual (Page 11)

MX10 Page 11
ASSEMBLY OF THE MX10
Now we are getting to the good stuff-assembling the MX10. We will begin by
mounting first the low parts, beginning with the parts on the side of the board
labeled as “PARTS” side on the PC board. When we are finished with that
side, we will begin to install parts on the “CONTROL” side of the board. This
side is where all of the controls go, and will be the side of the board facing the
top of the case. In the case of this project we will attempt to go from top to
bottom, left to right. Notice many of the resistors are “standing”, which allows
for a smaller PC board layout.
❒ 1. Orient the board as shown in the parts layout diagram.
❒ 2. Install R2, a 10K ohm resistor (brown-black-orange).
❒ 3. Install R7, a 10K ohm resistor (brown-black-orange).
❒ 4. Install R20, another 10K ohm resistor (brown-black-orange).
❒ 5. Install R16, a 10K ohm resistor (brown-black-orange).
❒ 6. Install R8, a 10K ohm resistor (brown-black-orange).
❒ 7. Install R21, a 10K ohm resistor (brown-black-orange).
❒ 8. Install R17, a 10K ohm resistor (brown-black-orange).
❒ 9. Install R92, a 1K ohm resistor (brown-black-red).
❒ 10. Install R34, a 10K ohm resistor (brown-black-orange).
❒ 11. Install R30, a 1K ohm resistor (brown-black-red).
❒ 12. Install R36, a 10K ohm resistor (brown-black-orange).
❒ 13. Install R3, a 10K ohm resistor (brown-black-orange).
❒ 14. Install R29, a 100K ohm resistor (brown-black-yellow).
❒ 15. Install R33, a standup 10K ohm resistor (brown-black-orange).
❒ 16. Install R32, a 220K ohm resistor (red-red-yellow).
❒ 17. Since U5 (LF347) can be considered a low profile part, we will install it
now. Notice that the IC has a dot or a notch indicating pin 1. This will be
installed in the same direction as shown in the parts layout diagram. This
part is responsible for the microphone amplifiers and the “soft clipping
circuits” we talked about in the circuit description. Make sure all 14 pins
are through the PC board before soldering the part to the board.