Rangemaster R6012 - Manual (Page 11)

9
ArtNo.325-0034 - Fitting the shelf 1
ArtNo.325-0035 - Fitting the shelf 2
ArtNo.325-0033 Oven BI shelf
�
�
�
�
A – Shelf guard, B – Front, C – Shelf stop
Key
ArtNo.325-0007 - Fitting the smooth-glide arm
���������
�������
����������
�������
�������������
����
Oven Accessories
The oven is supplied with two wire shelves, 2 smooth-glide
telescopic shelf arms and an enamelled grill pan, with a trivet
and a handle. The wire shelves slide into the wire supports
located on either side of the oven interior (Fig.2-25). The
telescopic shelf arms clip onto the wire shelves.
Fitting the Telescopic Arms
To fit the telescopic arm, locate the two retaining brackets
onto the wire frame. Push the bracket back onto the wire
frame until the spring clip ‘snaps’ the assembly to the frame.
The arm is now held in position on the wire shelf by two
spring-loaded retaining clips (Fig.2-26). To remove the arm,
locate the 2 retaining clips. Carefully open the spring clips
and lever the brackets away from the wire.
Removing the Shelf
Pull the shelf forward until the back of the shelf is up to the
shelf stop (Fig.2-27). Lift the front of the shelf so the stop
clears the wire support and pull clear (Fig.2-28).
Refitting the Shelf
To refit the shelf, line up the shelf with the shelf supports and
slide it between the two support wires until the shelf stop hits
the wire support. Lift the front of the shelf so that the stop
clears the support, then lower the front so that the shelf is
level and push it back fully.
The shelf guard should be at the back pointing upwards.
Fig.2-25
Fig.2-26
Fig.2-27
Fig.2-28