Rangemaster R6012 - Manual (Page 19)

17
INSTALLATION
Check the appliance is electrically safe when you have finished.
Electrical Connection
This appliance must be installed by a qualified electrician
to comply with the relevant Institute of Electrical
Engineers (I.E.E.) regulations and also the local electricity
supply company requirements.
WARNING: THIS APPLIANCE MUST BE EARTHED
Note: The appliance must be connected to the correct
electrical supply as stated on the voltage label on
the appliance, through a suitable cooker control unit
incorporating a double pole switch having a contact
separation of at least 3mm in all poles. This appliance must
not be connected to an ordinary domestic power point.
The mains terminal is situated on the back of the oven
(Fig.7-2).
Connect the cable to the correct terminals. Check that the
links are correctly fitted and that the terminal screws are tight.
Secure the mains cable using the cable clamp.
Ensure the cable route avoids the risk of trapping or touching
hot surfaces.
Current Operated Earth Leakage Breakers
Where the installation is protected by a 30mA sensitivity
residual current device (RCD), the combined use of your
appliance and other domestic appliances may occasionally
cause nuisance tripping. In these instances the kitchen circuit
may need to be reconfigured. This work should be carried out
by a qualified electrician.
Levelling
The worktop should already be fitted and levelled, and the
cabinets mounted 90° to the worktop. It is only necessary to
ensure the top front edge of the appliance unit supports the
front edge of the worktop and line up the appliance trims
with the doors.
Customer Care
Please complete your contact details in the front of this
section. Please inform the user how to operate the appliance
and hand over the instruction pack.
Thank you.
����������������������������������������������������
�
�
����
� � �
�
� ��
� �
�
�
Fig.7-2