ROTEL RSX-1550 - Manual (Page 50)

50 51
English RSX-1550 Surround Sound Receiver
50 51
English RSX-1550 Surround Sound Receiver
Note: Changing the default TUNER SETTING or REDIRECT
SETTING can only be done at the same time as restoring the
FACTORY DEFAULT settings. Therefore, we recommend selecting
your default TUNER and REDIRECT settings and resetting to the
FACTORY DEFAULT settings as the first step in configuring the unit,
before you change or memorize any other configuration settings.
To restore the FACTORY DEFAULT settings: Place the highlight
on the FACTORY DEFAULT line using the UP/DOWN buttons and use
the +/– buttons to change the setting to YES. Press the ENTER button
to proceed with resetting the FACTORY DEFAULT settings with re-
confirmation screen. The unit will power off (to Standby Mode) and then
on, with the factory settings restored. To return to the MAIN menu without
resetting the FACTORY DEFAULT settings, change the entry to NO and
press the ENTER button.
Note: Resetting to factory default settings will erase all stored
settings including delay settings, speaker settings, balance settings,
input settings and more. You will lose ALL system configuration
settings. Be certain that you wish to do so before resetting the
factory defaults.
To memorize USER DEFAULT settings: Many of the current
configuration settings can be stored as a USER DEFAULT, which can be
activated at any time from this menu screen.To save the current settings
as a USER DEFAULT:
1. Place the highlight on the SET USER DEFAULT line using the UP/
DOWN buttons and use the +/– buttons to change the setting to YES.
2. Press the ENTER button to go to confirmation screen where a
password must be entered. The default password is 8888. If the
entered password is correct, the current settings will be saved as the
new USER DEFAULT settings.
3. To return to the MAIN menu without saving changes, change all
entries on the screen to NO and press ENTER.
Note: If there is insufficient memory to store a USER DEFAULT
configuration file, the SET USER DEFAULT option will not be
available.
To activate memorized USER DEFAULT settings: After you have
stored a USER DEFAULT configuration file, you can activate those settings
at any time by placing the highlight on the USER DEFAULT line using the
UP/DOWN buttons. Use the +/– buttons to change the setting to YES.
Press the ENTER button to proceed with activating the USER DEFAULT
settings. To return to the MAIN menu without activating the USER
DEFAULT settings, change the entry to NO and press the ENTER button.
To return to the MAIN menu without activating the USER DEFAULT
settings, change the entry to NO and press the ENTER button.
To change the password: The password programmed at the factory is
0000. If you wish to change the password:
1. Place the highlight on the SET NEW PASSWORD line using the UP/
DOWN buttons. Use the +/– buttons to change the setting to YES.
Press the ENTER button to proceed to the PASSWORD screen.
2. Enter the four digits of the old password by pressing the +/– buttons
to select the first letter of the new password, then pressing ENTER
to move to the second character. Repeat until the old password is
entered. Successful entry of the old password will jump to the ENTER
NEW PASSWORD line.
3. Enter the four digits of the new password by pressing the +/– buttons
to select the first letter of the new password, then pressing ENTER
to move to the second character. Repeat until the new password is
entered.
4. You will be asked to re-enter the password again on the CONFIRM
PASSWORD line, following the same procedure. Once the password
is successfully confirmed, it will be saved and you will return to the
DEFAULT SETUP MENU automatically.
5 To exit the PASSWORD screen without changing the password,
highlight the DEFAULT SETUP MENU line and press ENTER to return
to the previous screen.
Note: The factory password is 0000. A default password that will
always be recognized is 8888.
RSX-1550 English v2.indd 50 27/8/08 14:22:29