Royal Sovereign BDH-450 - Manual (Page 7)

BDh-450 / BDh-550
7
OPeratiOn
control Panel
Power Button
The power button turns on and off. When you press the button, the unit begins to operate and the light will illuminate.
humidity
The humidity function will allow you to set the desired level of humidity you would like for the room. To set it, use the “-” or “+” button to set your desired level. The unit will turn on automatically
when the room humidity is higher than the selected level.
The humidity level may be set between level 30-80. The operational temperature for this unit is between 40 °F and 95 °F. If the temperature of the room falls below 40 °F, the unit will stop. This
helps to protect the compressor inside the unit.
note: The selected humidity may vary +,- 5%
fan speed
Press the fan button to change the fan speed.
Defrost light
If ice forms on the internal coils, the defrost light will light up. The dehumidifier will automatically go into auto defrost mode. The defrosting light will remain on until defrosting is complete. Once the
defrosting is complete, the unit will operate again.
water light
If for any reason the water is restricted from exiting the unit, the water light will be lit. Review the troubleshooting section of this manual for possible solutions.
FAN SPEED
HUMIDITY LEVEL
POWER
HIGH
LOW
DEFROST
WATER
FAN SPEED
HUMIDITY LEVEL
POWER
HIGH
LOW
MEDIUM
DEFROST
WATER
BDH-450 BDH-550