Ricoh GX100VF - Manual (Page 149)

147
C
h
a
n
gi
ng C
a
m
e
ra
Se
tti
n
g
s
5
Immediately after you press the shutter release button, the still
image taken is displayed on the screen for a moment so you can
check it. By default, the image confirmation time is set to 0.5
second, but this can be changed.
To change the image confirmation time, follow the steps below.
1
Display the SETUP menu.
• For the operating procedure, see P.135.
2
Press the " button to select [LCD CONFIRM.] and
press the $ button.
3
Press the !" buttons to select
the desired setting.
4
Press the MENU/OK button, or
press the # button and then
the MENU/OK button.
Caution------------------------------------------------------------------------------------------
When [LCD CONFIRM.] is set to 0.5 seconds, symbols such as the zoom bar may
remain on the monitor while the image is displayed.
Note ----------------------------------------------------------------------------------------------
It is convenient to set the image confirmation time to [30SEC.] to allow enough time to
view the image. This is particularly useful when using an LCD viewfinder. Even if you set
the image confirmation time to [30SEC.], you can half-press the shutter release button to
return to shooting mode and shoot a picture.
Changing Image Confirmation Time
(LCD CONFIRM.)
Available Settings
OFF (Image not displayed for confirmation)
0.5SEC. *Default setting
1 SEC.
2 SEC.
3 SEC.
30 SEC.