Ricoh LD335c - Manual (Page 161)

Where to Put Your Machine
149
6
• Close all covers and trays, in-
cluding the front cover and by-
pass tray.
❒ Move the machine carefully. If you
do not, it could result in damage
and stored files might be lost.
❒ Do not take off the holding stand.
❒ Protect the machine from strong
shocks. Impact can damage the
hard disk and cause stored files to
be lost. As a precautionary mea-
sure, files should be copied to an-
other computer.
Power Connection
R WARNING:
R CAUTION:
R CAUTION:
• When the main power switch is in
the stand-by position, the optional
anti-condensation heaters are on.
In an emergency, unplug the ma-
chine's power cord.
• When you unplug the power cord,
the anti-condensation heaters turn
off.
• Make sure the plug is inserted
firmly in the wall outlet.
• Voltage must not fluctuate by more
than 10%.
• The wall outlet shall be installed
near the machine and shall be eas-
ily accessible.
Access to the Machine
Place the machine near the power
source, providing the clearance areas
shown.
1. Rear: more than 10 cm (4")
2. Right: more than 55 cm (21.7")
3. Front: more than 70 cm (27.6")
4. Left: more than 46 cm (18.2")
Note
❒ For the required space when op-
tions are installed, contact your
service representative.
• Connect the machine only to
the power source described
on the inside front cover of
this manual. Connect the pow-
er cord directly into a wall out-
let and do not use an
extension cord.
• Do not damage, break or make
any modifications to the pow-
er cord. Do not place heavy
objects on it. Do not pull it
hard nor bend it more than
necessary. These actions
could cause an electric shock
or fire.
• Unplug the power cord from the
wall outlet before you move the
machine. While moving the ma-
chine, you should take care that
the power cord will not be dam-
aged under the machine.
• When you disconnect the power
plug from the wall outlet, always
pull the plug (not the cable).
AAE004S
JupiterC2_GSG_EN_Pre_FM.book Page 149 Tuesday, December 28, 2004 1:39 PM