Connecting specific instruments and devices, Connecting to a raymarine direct seatalk, Interface – Raymarine Marine GPS System User Manual
Page 171
Appendix A – Connecting Peripheral Instruments
A-7
Connecting Specific Instruments and Devices
The subsections that follow explain how to connect Navigator to
various manufacturers’ instruments and devices.
Connecting to a Raymarine Direct SeaTalk
™
Interface
You connect Navigator to a Raymarine Direct SeaTalk interface
(Part No. E85001) using Cable Part No. E86001 as shown in Figure
A-2. This interface converts the SeaTalk data format into RS-232
signals and vice-versa. When configuring your instrument
connections within Navigator, the COM port to which SeaTalk is
connected to must be set to:
Raymarine Direct SeaTalk Interface
.
Note:
Not all SeaTalk features are supported by the Z290 SeaTalk-to-
NMEA converter. If you are using an old Z290, you must set the
COM port to which it is connected to: NMEA 183 Instruments.
Figure A-2. Raymarine Direct SeaTalk Interface, Part No. E85001