Radio Shack Weather Radio - Manual (Page 21)

21 Operation
Clearing a HI/LOW Temperature
Alarm Setting
To clear the conditions for a high or low tem-
perature alarm so the alarm does not sound,
repeatedly press
ALARM to select the high or
low temperature condition, then repeatedly
press
until
   
appears.
Viewing the Indoor Dew Point
Temperature
Your weather station determines the current
dew point temperature once it receives tem-
perature and humidity data. Repeatedly
press
TEMP until
'(: '(: '(: '(:
and the recorded
dew point temperature appear.
Using the Indoor Dew Point
Temperature Alarm
You can set the monitor to sound an alarm
when the indoor dew point is within a specific
range (from 2–29°F or 1–16°C) of the current
indoor temperature.
Each time the indoor dew point temperature
changes and is within the programmed range
of the indoor temperature,
,1 ,1 ,1 ,1
flashes and the
monitor sounds an alarm for about 1 minute.
To silence the alarm sooner, press any key.
Note: If you press a key to silence the alarm,
the alarm stops sounding but
,1 ,1 ,1 ,1
and the cur-
rent readings continue to flash until the alarm
condition is no longer met.
Setting the Indoor Dew Point
Temperature Alarm
1. Repeatedly press TEMP until
''''(: (: (: (:
appears.
2. Repeatedly press ALARM until
$$$$/$50 /$50 /$50 /$50
appears.
3. Hold down SET until the indoor dew
point setting flashes.
4. Repeatedly press (or hold down) or
to set the dew point alarm condition.
5. Press SET to store the setting.
Note: If you do not press any button for
about 60 seconds, the monitor returns to the
current indoor dew point temperature dis-
play. To continue programming, start over at
Step 2.
Clearing the Indoor Dew Point
Temperature Alarm Setting
To clear the dew point alarm conditions so
the alarm does not sound, repeatedly press
TEMP until
'(: '(: '(: '(:
appears. Press ALARM
then repeatedly press until
   
appears.
USING THE OUTDOOR
TEMPERATURE WINDOW
The weather station samples the outdoor air
temperature about every 37 seconds. The
monitor shows both the current outdoor tem-
perature and the dew point temperature. You
can display the temperature in Celsius (°C)
or Fahrenheit (°F). Press
OUT , then
repeatedly press UNIT until
ƒ& ƒ& ƒ& ƒ&
or
ƒ) ƒ) ƒ) ƒ)
appears.
Notes:
• The monitor adjusts the unit of measure-
ment (Celsius or Fahrenheit) you see for
both the outdoor and indoor temperature
readings simultaneously.
• You can add up to three extra sensors
such as Cat. No. 63-1031 (not supplied,
available at your local RadioShack
store) to measure temperature readings
in different locations.
Viewing and Resetting Max/Min
Outdoor Temperature Records
To toggle between the current outdoor tem-
perature view and the maximum or minimum
outdoor temperature view (recorded since