RocketFish RF-900WPS - Manual (Page 7)

7 RF-900WPS
Installing your power supply
To make sure you connect your power supply correctly, check your
motherboard and graphics card manuals for compatibility before
connecting the RF-900WPS to any of your devices.
Notice: Cable management
This product uses color-coded sockets and cables for ease of use. Connect the plugs
to only those sockets with the same color ends. Red and blue sockets are to be used
for PCIe cables only. Black sockets are to be used for all other connections.
Warning: Failure to follow these instructions may result in damage to your computer
components.
To install your power supply:
1 Check your local AC voltage before installation (115 VAC voltage is for
USA, Japan, and several others, and 230 VAC voltage is for Europe,
Southeast Asia, and many other countries).
Caution: Make sure that you connect the power supply to local input AC voltage
only. Setting the incorrect voltage can damage the power supply and connected
equipment and may void your warranty. The RF-900WPS is compatible with 115 VAC
and 230 VAC input voltage.
2 Turn off your computer, then unplug the power cord from your old
power supply.
3 Open your computer case following the directions provided in your case
manual.
4 Disconnect all power supply connectors from the motherboard and
peripheral devices such as case fans, hard drives, floppy drives and DVD
and CD drives.
5 Remove the old power supply from your computer case and install your
new Rocketfish power supply.
6 Connect the 20+4-pin main power connector to your motherboard.
RF-900WPS 10-0861_MAN_ENG_V3.fm Page 7 Friday, August 13, 2010 1:52 PM