Ryobi DP120 - Manual (Page 12)

12
ADJUSTMENTS
Fig. 11
TABLE ADJUSTMENT
HANDLE
TABLE LOCK
HANDLE
0 0
10 20 30 40
10 20 30
40
12 Dr ll i Press
ON
WARNING:
Before performing any adjustment, make sure the drill
press is unplugged from the power supply and the switch
is in the OFF position. Failure to heed this warning could
result in serious personal injury.
ADJUSTING TABLE HEIGHT
See Figure 11.
■ Hold the table with one hand then loosen the table lock
handle.
■ To raise the table, turn the table adjustment handle
clockwise.
■ To lower the table, turn the table adjustment handle
counterclockwise.
■ Once the table is in the desired position, retighten the
table lock handle.
BEVEL ADJUSTMENT
See Figure 12.
Your drill press is equipped with a tilting table that allows you
to drill angled holes. The table can be tilted left or right, from
0°-45°.
To tilt the table:
■ Loosen the large hex bolt located beneath the table.
■ Use the bevel scale to tilt the table to the desired angle.
■ Retighten the hex bolt securely.
Fig. 12
HEX
BOLT
0 0
10
20
30
40
10
20
30
40
BEVEL
SCALE
TABLE LOCK
HANDLE
Fig. 13
DEPTH STOP
2 50
40
DEPTH
GAUGE
DEPTH STOP ADJUSTMENT
See Figure 13.
Where a number of holes are to be drilled to exactly the same
depth, the depth stop is used as follows.
■ Loosen depth stop.
■ Rotate depth gauge clockwise to desired measurement.
■ Retighten depth stop securely. This will stop the spindle
assembly at desired depth.