Reebok Fitness RL 645 RBEL79740 - Manual (Page 5)

5
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included allen wrenches, assembly requires a phillips screwdriver , two adjustable
wrenches , a rubber mallet , and pliers .
As you assemble the elliptical exerciser, use the drawings below to identify the small parts used for assembly.
The number in parenthesis below each drawing is the key number of the part, from the PART LIST on pages 24
and 25. The number following the key number is the quantity used for assembly. Note: Some small parts may
have been pre-assembled. If a part is not in the parts bag, check to see if it has been pre-assembled.
M10 x 92mm Carriage Bolt (124)–2
M6 Washer
(102)–2
M10 x 25mm Button
Screw (123)–3
M8 Washer
(132)–4
M8 x 35mm Button
Bolt (117)–2
M8 x 42mm Button
Bolt (116)–4
M4 x 16mm
Screw (99)–4
M8 Jam Nut
(91)–6
M10 Split
Washer (118)–3
M10 x 105mm Button Screw (89)–2
M4 x 16mm Round
Head Screw (125)–1
M6 x 16mm Button
Screw (103)–4
Bolt Set (101)–2
M10 Nylon
Locknut (90)–2
M8 x 52mm Button
Bolt (100)–4
M8 Split
Washer (122)–4
M4 x 25mm Round
Head Screw (115)–2
1. Identify the Front Stabilizer (29), which has Wheels (44)
attached to the front. While another person lifts the
front of the Frame (1), attach the Front Stabilizer to the
Frame with two M10 x 92mm Carriage Bolts (124) and
two M10 Nylon Locknuts (90).
1
29
44
1
124
90
A SSEMBLY