Reebok Fitness RL 645 RBEL79740 - Manual (Page 6)

6
33
39
1
Grease
103
41
41
103
40
40 Tubes
3. Identify the Ramp Axle (39), which is the longest axle.
Next, identify the Ramp Axle Covers (41), which are
smaller than the Wheel Covers (not shown). Slide a
Ramp Axle Cover onto an M6 x 16mm Button Screw
(103) as shown. Tighten the Button Screw into one
end of the Ramp Axle. Apply a small amount of the
included grease to the Ramp Axle.
Have a second person hold the two Ramp Bushings
(40) against the indicated tubes on the Frame (1).
Align the tubes on the Ramp (33) with the Ramp
Bushings; make sure that the Ramp is turned as
shown. Insert the open end of the Ramp Axle (39) into
the Ramp, the Ramp Bushings, and the Frame. If nec-
essary, tap the Ramp Axle with a rubber mallet to
insert it.
Slide the other Ramp Axle Cover (41) onto an M6 x
16mm Button Screw (103) as shown. Tighten the
Button Screw into the open end of the Ramp Axle (39).
Tubes
4
4. Slide an M6 Washer (102) onto an M6 x 16mm Button
Screw (103). Tighten the Button Screw into one end of
the Lift Axle (38). Apply a small amount of grease to
the Lift Axle.
Raise the Ramp (33). Insert the Lift Axle (38) into the
welded tube under one side of the Ramp, through the
motor screw, and then into the welded tube under the
other side of the Ramp. As you insert the Incline
Axle through the motor screw, make sure that the
motor screw does not turn.
Slide an M6 Washer (102) onto an M6 x 16mm Button
Screw (103). Tighten the Button Screw into the open
end of the Lift Axle (38).
38
Grease
Motor
Screw
102
103
33
102
103
3
2. While another person lifts the rear of the Frame (1),
attach the Rear Stabilizer (30) to the Frame with two
M10 x 105mm Button Screws (89).
30
1
89
2