Runco Video Xtreme VX-2000d - Manual (Page 46)

Installation
34 Runco VX-2000d Owner’s Operating Manual
PRE
L
IMINAR
Y
3.9
Installing and
Adjusting the
CineWide Anamorphic
Lens If you are installing a CineWide-equipped projector, proceed as follows to install and
adjust the anamorphic lens.
The standard VX-2000d/CineWide uses a prismatic-style anamorphic lens. This type of
lens compresses the height of the image (as opposed to stretching the width) to achieve a
2.35:1 aspect ratio with a 1.78:1 display device.
The standard VX-2000d Anamorphic lens mount kit consists of everything shown in Figure
3-16. Some components shipped with your projector may differ slightly from what is
shown in these instructions.
If any items are missing or damaged, please contact your Runco dealer or Runco
Customer Service at (800) 23-RUNCO.
Figure 3-16. VX-2000d Anamorphic Lens Mounting Assembly - Exploded View
1. Use the Pitch Adjustment Screws (item
#3) and Washers (item #6) to attach the
Mounting Brackets (item #2) to the
Anamorphic Lens (item #1).
2. Use the four Y-Adjustment Screws
(item #5) and Washers (item #4) to
attach the Anamorphic Lens assembly
and Spacers (item #7) to the front of the
projector. (Do not fully tighten the
screws yet.)
It is extremely important that the primary lens is properly
adjusted before you install the anamorphic lens. Ensure that
the image from the primary lens is perfectly centered on the
screen.
Note
3 Pitch Adjustment
Screw,
4-40 x 5/16"
(4x)
6 Fender Washer (4x)
2 Mounting Bracket (2x)
4 Washer (4x)
5 Y-Adjustment
Screw,
Phillips Pan-Head,
6-32 x 3/8" (4x)
1 Anamorphic Lens 7 Spacer (2x)