Runco Video Xtreme VX-2000d - Manual (Page 64)

Operation
52 Runco VX-2000d Owner’s Operating Manual
PRE
L
IMINAR
Y
Resolution: When using the VX-2000d with a computer or certain HD sources, you may
want to force the DHD Controller to use a specific output resolution. If so, select
Resolution from the Service menu and choose one. Then, press ENTER to confirm.
System Reset: To reset ALL controller settings (including image settings) back to their
factory defaults, choose System Reset from the Service menu.
A confirmation message appears, reminding you to save your settings before you perform
the reset, so that you can restore them afterwards. If you have done this, select Confirm to
continue with the reset. Otherwise, click Back to cancel.
Restore Saved Settings: Following a System Reset, select Restore Saved Settings to
apply all previously-saved settings to the projector and DHD Controller.
4.3
On-Screen Menus for
1080i (Digital) or
1080p Signals After you have finished calibrating the projector to optimize the display of 1080i analog
and lower-resolution sources, do likewise for 1080i digital and 1080p sources (connected
to the HDMI 1 or HDMI 2 inputs on the DHD Controller).
When the projector receives a 1080i digital and 1080p signal, it displays the menus shown
in Figure 4-6.
This action is not undoable. Proceed with caution! Before you
perform a System Reset, save ALL settings, including “Custom” ISF
Presets (page 46), ISF Day/Night presets (page 48), Output Shift
settings (page 48), Input Names (page 49) and Trigger settings
(page 51).
Caution