Royal Sovereign RSC-1400H - Manual (Page 6)

RSC-1400C/H
10 9 9
11. LOADING FILM
Royal Sovereign films are wound with the adhesive side facing the inside of the roll
(adhesive in).
Loading films to upper and lower film shafts:
(See page 5 for assistance with parts identification.)
1. Adjust the auto grip to fit to the film and tighten the
auto grip screw (Figure 1).
2. Remove the upper and lower film shafts from the
machine and load the films (Center the upper and
lower films on the shaft). Note the direction of the
adhesives on the lower and upper films
(Figure 2).
3. Load the upper and lower film shafts on the
machine (Figure 3).
Figure 1
Figure 2
Figure 3
10. USING CROSS CUTTER
Figure 1
Figure 2
Figure 3
The cross cutter is located on the rear exit table of the machine.
1. After lamination, move the cutter approximately to
the center of the completed application at the
desired point of detachment (Figure 1).
2. Grasp film with one hand, press the cutter
downward into the application and slide it from
one end to the other . (Figure 2 & 3).