Royal Sovereign RSC-1400H - Manual (Page 9)

RSC-1400C/H
16 15
4. Disassemble the power switch bracket and place the left
rewinder outside of the frame; fasten with round head
3/16"(M5) screws (included in the option kit). Then,
reinstall the power switch bracket (Figure 7).
5. Install the right rewinder on the outside of the frame and
connect the motor wire connector to the rear wire
(Figures 8 & 9).
6. Reinstall the rear cover.
7. Reinstall the side covers.
8. Reinstall the lever knob and screw.
Figure 7
Figure 8
Figure 9
Installation of the Front Feeder Option (Includes 2 brackets,
one spindle, and mounting hardware).
1. Install the Front Feeder to the inside of the front frames
using four 1/4"(M6) hexagon bolts on each side (Figure 1)
Installing the Rear Rewinder Option (Includes motorized
winder, bracket, one spindle, and mounting hardware).
1. Remove the left and right covers by using a Phillips
screwdriver (four screws on each side cover) (Figures 2 &
3).
2. Remove the lever knob screw and lever (Figure 4).
3. Remove the rear cover by removing all
10 screws (4 top, 4 bottom, and 1 on
each side) (Figure 5 & 6).
13. INSTALLATION OF FRONT FEEDER and REAR
REWINDER OPTIONS
Note: Below options are to be installed by an authorized RS reseller.
Figure 1
Figure 2 Figure 3
Figure 4
Figure 6 Figure 5