Russound UNO S2 - Manual (Page 13)

INSTALLER GUIDE
UNO-S2 Keypad Location
13
The best infrared remote performance is
achieved with the keypad installed away
from any direct sunlight, plasma TV, and low
voltage lighting controls. Also consider con-
venience when choosing a location.
Choose a place that is easily seen from
the position where a person is most likely
to be located.
Check whether or not you can route the
wire to the location you have chosen.
Keypad Installation
To install a double-gang keypad, you will
need to use a UL/CSA approved plastic
double-gang electrical box.
Route CAT-5 wire to the junction box from
the CAV6.6.
Use the supplied 110 punchdown tool to
connect each wire to its corresponding
color labeled on the punchdown terminal
(See page 12 for details).
Ensure jumper setting on the keypad is in
the “RUN” position.
Mount the keypad in the electrical box and
attach the cover plate. Repeat the steps
until all keypads are installed.