Roland E-09 - Manual (Page 21)

21
Song Functions
Using a Foot Switch to Punch In/Out
You can use a separately available foot switch (Roland DP series unit
or BOSS FS-5U) to start or stop recording. This lets you use both
hands for your performance; for example, allowing you to use your
left hand to operate the pitch bend/modulation lever while you use
your right hand to play the melody.
1. Connect the foot switch to the rear panel FOOT SWITCH
jack.
2. Press [FUNCTION] so it’s lit.
3. Use FAMILY [ ][ ] to select “KBD SET.” (p. 22)
4. Use SELECT [ ][ ] to select the “FSW” parameter. (p.
23)
5. Use TEMPO [ (-)][ (+)] to select “PunchI/O.”
6. Continue with step 1 and those that follow under “Punch-In/
Out Recording Mode.”
In steps 6 and 8 of “Punch-In/Out Recording Mode,” press the
foot switch instead of [
● REC].
1. Press [SONG] so it’s lit.
2. Press [ ] to return to the beginning of the song.
3. Press [ ] to start song playback.
4. Press [ ] once again to stop song playback.
You can use the following buttons to change the playback location
within the song.
• [ ]
Moves to the beginning of the song.
• [ ]
Moves to the preceding measure.
• [ ]
Moves to the next measure.
Repeat Playback of a Specified Region
You can specify a region (A–B) and play it repeatedly. You can do
this while the song is playing or while it is stopped.
fig.repeat
1. Use [ ][ ] to move to the measure at which you
want to start repeating.
2. Press [MARKER A-B] to set marker “A” to the current
location.
3. Use [ ][ ] to move to the measure at which you
want to stop repeating.
4. Press [MARKER A-B] to set marker “B” to the current
location.
5. Press [REPEAT A-B] so it’s lit.
6. If the song was stopped, press [ ] at this point to
begin repeat playback.
To cancel repeat playback, press [REPEAT A-B] so it goes out.
Don’t set the marker at the last measure of the song; repeat
playback will not work correctly if you do this.
Here’s how you can mute (silence) a specific track of the song.
Muting a Track
1. Press [DRUMS & BASS] (factory setting: track 10),
[COMBO] (factory setting: track 1), or [FULL] (factory
setting: track 2) to specify the track you want to mute.
2. Press [ ]. The song begins playing, with the track you
specified in step 1 muted.
Changing the Muted Tracks
You can change the track that is muted by each of the buttons
[DRUMS & BASS], [COMBO], and [FULL].
1. Hold down one of the buttons [DRUMS & BASS], [COMBO],
or [FULL].
The mute track setting screen will appear.
2. Use TEMPO [ (-)][ (+)] to change the track that is
muted by that button.
Playing the Song
Changing the Playback Location of
the Song
Minus-One Playback
E-09_e.book 21 ページ ２００５年１１月２１日 月曜日 午前１１時２４分