Roland MP-500 - Manual (Page 31)

31
Connecting to MIDI Devices
Read this chapter if you wish to connect the MP-500 to an
external MIDI device.
If the MP-500 is connected to a MIDI sequencer, such as one
from the MT series, a performance recorded on the MP-500
can be transmitted to the MIDI sequencer. It is also possible
to record the performance directly on the MIDI sequencer.
The recorded performance can be saved on the MIDI
sequencer.
When the MP-500 is connected to an MT series sequencer, the
rich variety of sounds built into the MT series sequencer can
be played from the keyboard of the MP-500.
About the MIDI Connectors
fig.8-01.e
MIDI In Connector
Use a MIDI cable (sold separately) to connect from here to
the MIDI Out connector on the external MIDI device.
MIDI messages sent from connected external equipment will
be received here. As a result, the MP-500 will produce sound,
change tones, or perform other operations.
MIDI Out Connector
Use a MIDI cable (sold separately) to connect from here to
the MIDI In connector on the external MIDI device.
Performance data detailing what has been played on the
keyboard, and other data, such as that generated when a
pedal is depressed, is sent out from here to external MIDI
devices.
Making the Connections
NOTE
To prevent malfunction and/or damage to speakers or other devices,
always turn down the volume, and turn off the power on all devices
before making any connections.
1. Turn the volume down completely on all
equipment.
2. Turn off the MP-500 and any other devices
to be connected.
3. Use the optional MIDI cable to connect the
MIDI connector on the external MIDI device
to the MIDI connector on the MP-500.
Take a look at the connection examples.
4. Turn on the power to all equipment.
5. Adjust the volume.
6. You should also make the following
settings as needed.
For details on making MIDI-related settings for the
MP-500, refer to p. 32 through p. 35.
Connection Examples: Connecting to a
sequencer (The Roland MT Series)
fig.8-02.e
Connection Examples: Connecting to a MIDI
sound module
fig.8-03.e
About MIDI
MIDI, short for “Musical Instrument Digital Interface,”
was developed as a standard for the exchange of
performance data between electronic instruments and
computers.
The MP-500 is equipped with MIDI connectors to allow
such exchange of performance data with external
equipment and devices. Connecting the keyboard to
other devices with these jacks provides you with an even
greater variety of ways to use your keyboard.
In Out
MIDI
MIDI connectors on the rear panel
MT Series
MP-500
In Out
MIDI Pedal
In Out MIDI
* The MT-90s has no MIDI Out connector.
Sound Module
OUT THRU IN
MIDI
MP-500
In Out
MIDI Pedal
MP-500.e.book 31 ページ ２００３年６月１１日 水曜日 午前９時４６分