Connecting to ac power, Projector/dhd controller, Autoscope lens motor – Runco QUANTUM Q-750D User Manual
Page 55: 7 turning on the power, Turning on the power, Pre l iminar y
Q-750d Series Installation/Operation Manual
39
PRE
L
IMINAR
Y
Connecting to AC Power
Projector/DHD Controller: Plug the female end of one power cord into the AC
receptacle on the rear of the Q-750d (AC 100V ~ 240V). Then, connect the other end to
your AC power source.
Similarly connect the DHD Controller to a nearby AC outlet.
AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power
cord is provided for the lens motor. Plug the female end of the AC power cord into the AC
input on the rear of the lens motor assembly. Connect the other end to your AC power
source.
3.7
Turning on the Power
1.
Turn on your source components.
2.
Turn on the main power switch at the rear of the DHD Controller.
3.
If this is an AutoScope-equipped projector, turn on the main power switch at the rear
of the AutoScope lens motor. The lens motor power switch is located next to the AC
input.
4.
Press the ON button on the remote control (or the ON/STANDBY (
) button on
DHD Controller front panel) to turn on the system. The vacuum fluorescent display on
the DHD Controller front panel briefly displays “Initializing System,” followed by
“Starting Q-750d.” On the projector, the LED flashes green to indicate that it is
warming up.
5.
When the projector is ready for use, the LED turns off. On the DHD Controller, the
fluorescent display indicates the active source, input resolution/frame rate and aspect
ratio; for example:
Q-750d HDMI
1
16:9 1080i/60
Current
Source
Aspect Ratio
Input Resolution/Frame Rate