Connecting external speakers (optional), Figure 3-8 . external speaker connection, Connecting to a dolby digital amplifier – Runco CX-52HD User Manual
Page 33: Figure 3-9 . digital audio connection, 8. external speaker connection, 9. digital audio connection, Pre l iminar y
Runco CX-52HD/CX-57HD Owner’s Operating Manual
21
PRE
L
IMINAR
Y
Connecting External
Speakers (Optional)
Connect the
(positive) and
(negative) speaker wires to the rear-panel SPEAKER-R
and SPEAKER-L terminals; see Figure 3-8. Maintain the correct polarity. For more
information, refer to the owner’s manual for your speakers.
Figure 3-8. External Speaker Connection
Connecting to a Dolby
Digital Amplifier
If your home theater has a Dolby Digital amplifier or receiver, connect the digital audio
output from the Crystal Series LCD to the digital audio input of the amplifier/receiver as
shown in Figure 3-9. The Crystal Series LCD supports both coaxial (S/PDIF) and optical
(TosLink) digital audio connections.
Figure 3-9. Digital Audio Connection
12 mm
Twist exposed
wire strands
together.
Right Speaker
Left Speaker
Push tab to the
open position, and
insert the wire.
Then, close tab firmly to
secure the wire in place.
The audio output level is fixed. (The volume and mute controls affect
only the speaker and headphone outputs.)
Note
Digital Audio Cable,
Optical
(Sold Separately)
Digital Audio Cable,
Coaxial
(Sold Separately)
Dolby Digital
Amplifier
- or -