Gamma, Save settings, Restore settings – Runco CX-52HD User Manual
Page 45: Audio, Balance, Equalizer, Pre l iminar y
Runco CX-52HD/CX-57HD Owner’s Operating Manual
33
PRE
L
IMINAR
Y
Each color temperature setting has six (6) “white balance” parameters associated with it
(two each for red, green and blue). These are described later in this section; refer to White
Balance on page 41.
Gamma: The Gamma control determines how gray shades are displayed between
minimum input (black) and maximum input (white) for all signals. A good gamma setting
helps to optimize blacks and whites while ensuring smooth transitions for the
“in-between” values utilized in other grays.
Unlike brightness and contrast controls, Gamma allows you to lighten or darken the
overall tone of your images without changing the extremes. All images will be more vibrant
while still showing good detail in dark areas.
The default Gamma setting of 2.20 is appropriate for most typical home theater
environments.
Save Settings: The Crystal Series LCD lets you save image quality settings for each input
and supported resolution to a preset. You can recall this preset at a later time by simply
pressing a button on the remote control or using the Restore Settings menu command
(see below).
You should save changes to any of the following settings to a preset; otherwise they will
be lost when a new input source or resolution is selected:
• Brightness
• Contrast
• Color saturation
• Tint
• Sharpness
• Gamma
• Color temperature selection (5400, 6500, 8500 or Custom)
Restore Settings: To recall a preset, choose Restore Settings from the Picture Adjust
menu and select “Custom,” “ISF Day” or “ISF Night.” Or, use the corresponding buttons
on the remote control.
Audio
To adjust the Crystal Series LCD audio settings, select Audio from the Main Menu and
press ENTER.
Balance: To adjust the left/right speaker balance, select Balance from the Audio Menu
and press ENTER. Use the left- and/or right-arrow buttons to make one channel louder
than the other.
Equalizer: The Crystal Series LCD has a five-band graphic equalizer that you can use to
boost or cut certain audio frequencies. To use it, select Equalizer from the Audio menu
and press ENTER. Select one of four equalizer presets – Standard (flat), Music, Film or
Speech – or select Custom to create your own according to taste. The five frequency
bands are 100, 300, 1000, 3000 and 10,000 Hertz (Hz).