RCA RCU500 - Manual (Page 5)

3
TV/VCR Connection
The basic connection (TV and VCR), right, is the most common
connection and is therefore used to illustrate a single component
connection with your TV.
Cables
You will use either of the following type of cable to make your
connection:
Coaxial Cables: Carries the signal from the
antenna or cable directly to the television or
through a cable box, as needed by your cable
system.
Audio/Video Cables: Carries audio and video from a
component to the TV.
How to View the VCR
To watch the VCR with the connection using the CABLE/ANTENNA jack,
tune the TV to Channel 3 or 4. To watch the VCR with the connection
using the AUDIO/VIDEO in jacks, tune the TV to the Video Input (press
0, 0 on the remote).
VCR 1
TV
AUDIO VIDEO
OUT
IN FROM ANT
OUT TO TV
CH3
CH4
AUDIO VIDEO
CABLE/
ANTENNA
CABLE, CABLE BOX, OR ANTENNA CABLE, CABLE BOX, OR ANTENNA
VCR 1
AUDIO VIDEO
OUT
IN FROM ANT
OUT TO TV
CH3
CH4
TV
CABLE/
ANTENNA
AUDIO VIDEO
CABLE, CABLE BOX, OR ANTENNA
OR
GETTING STARTED
TIP
Your TV is equipped with an audio/
video input. To tune to the audio/
video input, press “0, then 0” (zero
button twice) on the remote. The
audio/video input can also be
added to the channel scan list and
accessed by the channel up and
down buttons.