Radio Shack TAD-729 - Manual (Page 10)

10
Note: To mount the TAD directly on a
wall, you need two screws (not supplied)
with heads that fit into the keyhole slots
on the bottom of the base. Follow the
steps under “On a Wall Plate or Wall” on
Page 9, then apply these additional in-
structions for placement on a wall.
1. Drill two holes 3 15 /
16
inches (100 mm)
apart. Then thread
a screw into each
hole, letting the
heads extend about
5 /
16
inch (8 mm)
from the wall.
2. Plug one end of the supplied long
modular cord into the TEL LINE jack
at the back of the base.
3. Align the bracket’s keyhole slots
with the mounting screws and slide
the base downward to secure it.
CONNECTING AND
CHARGING THE BATTERY
PACK
The TAD-729 comes with a recharge-
able nickel-cadmium battery pack in-
stalled in the handset, but not
connected. Before using your phone,
you must connect the battery pack, then
charge it for about 24 hours.
1. Press down and slide off the battery
pack compartment cover.
2. Lift the battery pack out of the com-
partment. Plug the battery pack’s
connector into the socket in the
compartment. The connector fits
only one way.
3. Put the battery pack in the compart-
ment.
4. Replace the cover.
To charge the battery pack, simply place
the handset on the base, facing either
up or down. The CHARGE/IN USE indi-
cator on the base lights.