Radio Shack TAD-729 - Manual (Page 12)

12
1. Set DIAL MODE to T (tone).
2. Lift the handset and listen for a dial
tone.
3. Press any number other than 0 .
Note: If your phone system requires
that you dial an access code (9, for
example) before you dial an outside
number, do not press the access
code number either.
If the dial tone stops, you have
touch-tone service. Leave
DIAL
MODE set to T . If the dial tone contin-
ues, you have pulse service. Set
DIAL MODE to P (pulse).
4. Press TALK or place the handset on
the base to hang up.
TURNING THE BASE’S
RINGER OFF AND ON
To turn off the base’s ringer, set RINGER
on the back of the base to OFF . You can
still make or receive calls using this
phone. Telephones on the same line
(and the TAD's handset if it is away from
the base) still ring when there is an in-
coming call.
To turn on the base’s ringer, set RINGER
to ON .
SETTING THE RINGER
TONE/VOLUME
You can select one of four different ring-
er tone/volume settings while the phone
is not in the talk mode. Press or to
increase or decrease to the ringer level
setting.
Repeatedly press or until you hear
the desired ringer setting. Each time you
press or , the ringer changes and
the display shows
Ringer A High ,
Ringer A Low , Ringer B High , or
Ringer B Low .
Note: Pressing when the display
shows
Ringer A High or when the
display shows Ringer B Low does not
change the setting. Press the other but-
ton to change the setting.
DIAL MODE
RINGER