Olympus LS-11 - Manual (Page 24)


Ab
ou
t R
ec
ord
ing
2
e
d
 Press the STOP 4 button to stop re-
cording.
• [ ] will go out on the display.
e File length
Actually producing the sound you
would like to record:
• When a loud sound is produced the level
meter will swing all the way over to the right
while recording and the [PEAK] indicator
light will turn on. When this happens the
sound will be recorded in a distorted man-
ner since the recording level is too high.
When the level meter is
maxed out (the recorded
sounds will be distorted)
Example of conditions
where the recording level
has been lowered and the
excess input has been
adjusted
• When a loud noise is produced, adjust
the recording level so that the level meter
remains in the vicinity of [–6].
 Press the REC s button again will
begin recording.
• [ ] will appear on the display.
d Elapsed recording time
Notes
• The recording will continue even if the volume
of a single file exceeds 2 GB in the linear PCM
format recording (☞ P.43).
1 The file is saved every 2 GB in separate
files. It will be treated as multiple files when
playing back.
2 When the recording exceeds 2 GB, the
number of files in the folder may exceed
200 files. The 201st file and later will not
be recognized by the recorder, so check by
connecting the recorder to a PC.
• When an SD Card is inserted in the recorder,
be sure to confirm the recording media as either
[Built-in Memory] or [SD Card] so that there is
no mistake (☞ P.41, P.46).
• When attempting to perform operations such as
rewriting the contents of an SD Card in cases
where the card has been write protected, [SD
Card Locked ] will appear. The playback opera-
tion can be performed, but the write protection
must first be turned off when overwriting the
contents on the card (☞ P.18).
• If you select a folder other than [A] through [E]
and press the REC s button, an [Can't record
in this folder ] message will flash. Select a
folder from [A] through [E] and start recording
again.
Recording