Omega DPS3100 - Manual (Page 25)

Page 24
MOUNTING
3.70” (94mm)
4.05 ” (10 2.87 mm)
1.77”
(45mm)
0.15” dia. (3.81mm)
Figure - 4. Panel Cutout and mounting hole dimensions
1. Cut out Panel and mounting hole dimensions as shown in the figure 8.
2. Remove the nuts from the mounting screws on the Panel Meter.
3. Insert panel meter into the hole until it is flush with the panel.
4. Install the nuts and tighten them till the unit is held firmly against the panel.
1. Remove nuts and insert
Panel Meter & screws in
mounting holes in panel
cutout
2. Tighten the nuts, after
mounting the unit in the
panel cut out, till the unit is
held firmly against the panel.