Oster TM20 - Manual (Page 5)

BREWING ICED TEA
1. Fill the pitcher with fresh, cold water to
the water level marked on the pitcher.
Do not overfill.
2. Rotate the brew head and pour water into
the water reservoir (Figure 1).
3. Open top lid and add the desired amount
of tea. You may also add sugar, lemon or
other flavorings to the brew basket to suit
your taste.
NOTE: 5-7 bags of tea or 2-3 tbsp. of loose tea
is recommended when brewing 2.5 quarts
of iced tea.
4. Rotate the shower head position so that
it is over the brew basket. Close the top lid
(Figure 2).
5. Adjust the steeping lever to your desired
brew strength.
6. Fill the pitcher with ice cubes to the ice level
marked on the pitcher. If you are low on ice,
you may substitute cold water, refilling the
pitcher to the WATER level marked on the
pitcher. DO NOT fill to the ice level as this
will cause an overflow when the tea brews.
7. Slide the pitcher towards the iced tea maker
and rest flush against the appliance.
NOTE: Make sure the rotating brew head is centered over the pitcher before
turning on the iced tea maker.
8. Turn the iced tea maker on by plugging the power cord into an electrical
outlet and pushing the “on” button firmly until the ON indicator light is
illuminated.
9. When the brewing cycle is complete, the iced tea maker will shut off
automatically. Wait 30 seconds, then slide the pitcher away from the
appliance and serve your iced tea. Your tea may turn cloudy as it
chills due to the presence of naturally
occurring tannic acids found in tea.
10. After you are done enjoying your iced tea beverage, wait for the iced tea
maker contents to cool down before handling. Then open the lid, rotate
the shower head out of the way and remove brew basket. Discard the
contents and rinse it with clean water.
8 7
Max
Figure 1
Figure 2
CLEANING AND MAINTAINING YOUR ICED TEA MAKER
Cleaning your Oster ® Iced Tea Maker
Turn off and unplug cord. Clean only with a damp cloth.
Hard water can leave mineral deposits inside the pitcher and the brew basket.
To remove these, fill the brew basket and the pitcher with warm, undiluted
white household vinegar. Let soak for 20 minutes, then rinse.
Never use harsh, abrasive cleansers, steel wool pads or other abrasive
materials. They may cause scratches which can lead to breakage.
CAUTION! Never immerse the iced tea maker itself in water, in any other liquid
or in the dishwasher.
Decalcifying your Oster ® Iced Tea Maker
Mineral (calcium/limestone) found in the water will leave deposits in your iced
tea maker and will affect its performance. If you notice an increase in
steaming or if the pumping action stops before all of the water has been
pumped out of the appliance, it’s time to clean it. The frequency of cleaning
depends on the hardness (mineral content) of your tap water. Please see
the following chart:
It’s recommended that you regularly remove mineral deposits by using
undiluted, white household vinegar.
1. Pour one quart of undiluted, white household vinegar into the water reservoir.
2. Place the pitcher lid on the pitcher and slide the pitcher into place under the
Rotating Brew Head.
3. Push the “on” button to begin the brewing cycle. After one cup of vinegar
has pumped into the pitcher, unplug the iced tea maker. Let it stand for
30 minutes.
4. Plug in the iced tea maker again. Continue brewing process again to pump
out the remaining cleaner or vinegar.
5. When the iced tea maker shuts off, unplug it, remove the pitcher and
discard the cleaning solution.
6. Fill the pitcher with clean tap water to the water level marked on the
pitcher and repeat Steps 1-5 without the cleaning solution. Repeat this
process if necessary.
Suggested Cleaning Interval
Type of Water Cleaning Frequency
Soft Water Every 80 Brew Cycles
Hard Water Every 40 Brew Cycles
BVST_TM20_09ESM1.qxd:Layout 1 4/21/09 10:53 AM Page 7