Onkyo AV Receiver HT-R791 - Manual (Page 97)

En-1
E n
7.1ch Home Theater Speaker Package
Make sure you have the following accessories.
Front speakers (SKF-791)
Center speaker (SKC-791)
*1 Configuration of the cork stoppers may be different from the
figure, such as being 2 sheets instead of 1 sheet, but the total
number will be same.
Surround speakers (SKR-780)
Surround back speakers (SKB-780)
Powered subwoofer (SKW-791)
Caution
• The front grilles are not designed to be removed so do not
attempt to remove them forcibly, as this will damage
them.
■ Front
■ Rear
Supplied Accessories
Front speakers Speaker cables 10 ft. (3.0 m)
2 speaker bases and
8 screws
Center speaker Speaker cable 10 ft. (3.0 m)
4 cork stoppers *1
(White) (Red)
(Green)
Surround speakers
Surround back
speakers
Speaker cables 26 ft. (8.0 m)
RCA cable 10 ft. (3.0 m)
Subwoofer 4 floor pads
Part Names
(Blue) (Gray)
(Brown) (Tan)
Speaker terminals
SKF-791
Speaker terminals Keyhole slots
SKC-791
Speaker terminals
Keyhole slot
SKR-780/SKB-780
Status indicator
Off: Subwoofer in standby mode or
disconnected from power source
Blue: Subwoofer on
With the Auto Standby function, the
SKW-791 automatically turns on when an
input signal is detected in standby mode.
When there’s no input signal for a while,
the SKW-791 automatically enters
standby mode.
SKW-791
To AC outlet
OUTPUT LEVEL control
This control is used to adjust the
volume of the subwoofer.
LINE INPUT
This RCA input should be connected
to the subwoofer pre out on your AV
receiver with supplied RCA cable.
SKW-791
HTP-791