Onkyo R-805TX - Manual (Page 15)

15
If your other components are made by ONKYO and those components are equipped with
connectors, you can control the
-connected components with the supplied remote control-
ler.
Before connecting
• The unit must be connected in the
system hookups for control operations.
• Each component has two connectors. There is no difference between these connectors.
• The components may be connected in any order.
• The hookups on the previous page are necessary independently of the
system hookups.
The illustration below is an example of a hookup.
Connections
You can connect the power cord from
another audio device to the rear of the R-
805TX.
If the R-805TX is connected via an
remote control cable to another Onkyo
audio device that has a STANDBY/ON but-
ton, you can use the STANDBY/ON button
on the R-805TX to turn on and off the
power to both R-805TX and connected
device, or place both devices in standby
mode. When the R-805TX is turned on or
placed in standby mode, electric current is always supplied to the AC connector on the rear
panel. If you press the ENERGY SAVE button while the R-805TX is in standby mode, the power
to the connected audio device will be turned off one minute later. (See page 20.)
The shape and capacity of the AC outlet may differ depending on the area of purchase. Make
sure that the capacity of other components connected to this unit does not exceed the capac-
ity that is printed on the rear panel.
Connecting the remote control cables
remote control cable (supplied with
every ONKYO component that has
connectors except for the amplifier and
receiver)
This unit
MD recorder
Stereo cassette
Audio
CD player
tape deck
(R-805TX)
• This is not an example of stacking the
components. For the example, refer
to page 9.
CD recorder
AC outlet connection
L
R
SPEAKERS
OUT IN
L
R
OUT MD
CDR TAPE
CD IN LINE/DVD PROCESSOR
OUT IN OUT IN
REMOTE CONTROL
L
R
L
R
L
R AM
FM 75
ANTENNA
CAUTION:
SPEAKER
IMPEDANCE
4 OHMS MIN.
/SPEAKER
AC OUTLET
AC 230-240V
50Hz
SWITCHED
100W MAX.
Capacity is 120 watts.
120 V, 60 Hz models 230-240 V, 50 Hz models
Capacity is 100 watts.