O2 Innovations CTA-08 - Manual (Page 11)

Mouthpiece Filter Change:
1. Remove the cloth Mouthpiece Cover from the Headset.
2. Press the latch on the Mouthpiece Filter Cover and remove the cover.
3. Replace the used Mouthpiece Filter with a new one (additional filters may be purchased from a dealer
near you or at o2-b.com).
4. Reinstall Mouthpiece Filter Cover and cloth Mouthpiece Cover.
5. Replace Mouthpiece filter monthly.
6. Change Mouthpiece Filter every time a different aromatherapy essential oil is used.
Cleaning the Headset Hose and Headset:
1. Separate headset hose from unit and from headset. (Reverse directions on page 6, Figure 8).
2. Remove Mouthpiece Filter from Headset. (See Mouthpiece Filter Change above)
3. Soak Hose and Headset in warm water and an anti-bacterial/germicidal soap for 2-3 minutes.
4. Rinse thoroughly with warm water.
5. Allow to air dry in a clean, shady area.
6. Re-attach the parts to the unit:
- Insert the Mouthpiece Filter into the Headset and replace the Mouthpiece Filter Cover.
- Connect one end of the Headset Hose to the Unit.
- Connect the other end of the Headset Hose to the Headset Oxygen Inlet.
NOTE
DO NOT use washing detergent, benzene, thinner or alcohol, etc. It may damage, deteriorate or discolor
the product.
DO NOT dry the product with a hair dryer or heater. It may cause deterioration or breakdown of the
product.
10
Figure 14
Mouthpiece Cover Mouthpiece Cover Filter
Latch
Mouthpiece Filter Cover