Speaker distance, Level calibration, Go to “level calibration – Onkyo TX-NR717 User Manual

Page 56: Before, En-56

Advertising

Advanced Operations

En-56

When the “Powered Zone 3” setting is set to “Yes”, this
setting cannot be selected.

■

Surround Back Ch

1ch:

Select if only one surround back speaker L is
connected.

2ch:

Select if two (left and right) surround back speakers
are connected.

Note

• If the “Surround Back” setting is set to “None”, this setting

cannot be selected.

■

LPF of LFE
(Low-Pass Filter for the LFE Channel)

80Hz, 90Hz, 100Hz, 120Hz

Off:

Low-Pass Filter is not applied.

With this setting, you can specify the cutoff frequency of
the LFE channel’s low-pass filter (LPF), which can be
used to filter out unwanted hum. The LPF only applies to
sources that use the LFE channel.

Note

• If you’re using THX-certified speakers, select “80Hz”.

■

Subwoofer Phase

0º

180º:

Moves the subwoofer phase.

Note

• If the “Subwoofer” setting is set to “No”, this setting cannot be

selected.

■

Double Bass

Off(THX)

Turn this setting on to boost bass output by feeding bass
sounds from the front left, right, and center channels to
the subwoofer.

Note

• When the “Subwoofer” setting is set to “No” or the “Front”

setting to anything other than “Full Band”, this setting is fixed to
“- - - - -”.

• This setting is set to “On” automatically when the “Subwoofer”

and “Front” settings are set for the first time to “Yes” and “Full
Band” respectively.

• If you’re using THX-certified speakers, select “Off(THX)”.

Speaker Distance

Here you can specify the distance from each speaker to the
listening position so that the sound from each speaker
arrives at the listener’s ears as the sound designer intended.

■

Unit

feet:

Distances can be set in feet. Range: 0.5ft to 30.0ft in
0.5 foot steps.

meters:

Distances can be set in meters. Range: 0.15m to
9.00m in 0.15 meter steps.

(The default setting varies from country to country.)

■

Left, Front Wide Left, Front High Left, Center,
Front High Right, Front Wide Right, Right,
Surround Right, Surround Back Right, Surround
Back Left, Surround Left, Subwoofer

Specify the distance from each speaker to your
listening position.

Note

• Speakers that you set to “No” or “None” in

“Speaker Configuration” cannot be selected (

➔ page 55

• When the “Powered Zone 2” setting is set to “Yes” and Zone 2

is turned on, the surround back and front high speakers cannot be
used.

• When the “Powered Zone 3” setting is set to “Yes” and Zone 3

is turned on, the surround and surround back speakers cannot be
used.

Level Calibration

Here you can adjust the level of each speaker with the
built-in test tone so that the volume of each speaker is the
same at the listening position.

Note