Oki B930d - Manual (Page 89)

B930n User’s Guide> 83
The printer LPD supports Spool Mode where print jobs from clients
are spooled once before output and Non-spool Mode where print
jobs are sequentially output without spooling.
NOTE
When the LPD port is used, the printer can limit print instructions
by IP addresses.
TARGET COMPUTERS
The target computers are as follows:
• Workstation or personal computer with RFC 1179 Line Printer
Daemon Protocol. LPD (TCP/IP) UNIX
INTERFACE
The printer LPD is available on the following interfaces:
• Ethernet 100BaseTX
• Ethernet 10Base-T
The applicable frame types conform to Ethernet II.
SET UP PROCEDURE
The setting procedure is as follows:
1. Setting up the printer
Set the IP address on the printer Operator Panel.
Use the printer Operator Panel or the EWS to set the LPD port
to [Enable] (default: [Enable]).
NOTE
> Before activating the LPD port, set the IP address of the
printer. For details on how to set the IP address and the
port, refer Printer Configuration.
LPD (TCP/IP)