Outback Power Systems OUTBACK TROOPER 359 - Manual (Page 16)

16
Problem Possible Cause Solution
Burners will not light using the
ignition system LP gas cylinder is empty Replace with full cylinder
Faulty regulator Have regulator checked or replace
Obstructions in burners Clean burners
Obstructions in gas jets or gas hose Clean jets and gas hose
Electrode wire is loose or disconnected on
electrode or ignition unit
Reconnect wire
Electrode or wire is damaged Change electrode and wire
Faulty integral ignitor Change ignitor
Burner will not light with a match LP gas cylinder is empty Replace with full cylinder
Faulty regulator Have regulator checked or replace
Obstructions in burners Clean burners
Obstructions in gas jets or gas hose Clean jets and gas hose
Low flame or flashback (fire in burner
tube— a hissing or roaring noise may
be heard) LP gas cylinder too small Use larger cylinder
Obstructions in burners Clean burners
Obstructions in gas jets or gas hose Clean jets and gas hose
Windy conditions Use BBQ in a more sheltered position
Gas valve knob difficult to turn Integral ignition system jammed Replace gas valve
Gas valve jammed Replace gas valve
For reference and correspondence, record your serial number
here.(See sticker on side of barbecue body.)
Serial No.
__________________
This number may be required when ordering spare parts or
accessories. A part reference number may also be required
where applicable.
K. Troubleshooting
Published September 2006’